Operating procedures for wall washer

Operating procedures for wall washer

1.During the installation and maintenance LED wall washer, it should be ensured that the power supply can be cut off before operation.

2.The LED Wall Washer Light is only suitable for installation on the surface of non-combustible things, and the surface of the luminaire cannot be covered with heat insulating pads or similar things at any time.

3. The high-power wall washer should be wired correctly, the red wire is connected to the live wire, the green wire is connected to the ground wire, and the blue wire is connected to the neutral wire, and it must be firm.

4. After the incoming wire enters the lamp through the outlet, the outlet should be tightened to prevent rainwater from penetrating into the lamp body through the incoming wire and causing electrical damage.

5. There should be no corrosive, flammable and explosive things around the high-power wall washer.

6. The parts connected with the light stand should be firm to prevent accidents caused by factors such as natural disaster.

7. The input voltage is allowed to fluctuate within the range of 95% to 105% of 220V. Excessive fluctuations will affect the life span and light sources, light efficiency, color rendering, and normal startup and ignition.

8. The Linear LED Wall Washer is equipped with 1W LED light source, and the power has 12W, 18W, 24W, 36W,48W.

9. The lamp is made of 3MM tempered glass. If it is damaged, please send it back to Green Art led company for replacement and repair. Do not replace it by yourself.

10. In order to ensure the normal service life of the lamp, the lamp cannot work continuously for a long-time during use. Generally, the power supply must be cut off in time for about 8 hours of normal use, and the lamp body can be restarted after cooling down (about 20 minutes).

11. The waterproof of this light is IP65, and it cannot be used in places where water is easy to accumulate or underwater.