Common problems and solutions of wall washers

LED wall washers are widely used in building exterior lighting. Today we analyze the problems existing in the application of LED wall washer:

1. Heat dissipation problem

2. Lack of standards and uneven products

3. The product is easy to enter water, causing short-circuit damage to the electronic source device

4. The product is not moisture-proof, and the temperature difference is too large, water mist will form on the glass surface, affecting the lighting effect

5. There are problems with price and design quality.

Solutions to common problems of LED wall washer:

1. The power supply and the light source are installed separately, the heat of the power supply and the light source do not overlap, and the heat dissipation is more direct and effective, which is beneficial to prolong the service life of the power supply and the light source.

2. Exquisite appearance, simple installation and certain concealment.

3. After the integrated lens is sealed, the electrical components are completely isolated from the air, and the waterproof level can reach IP65.

4. There are ventilation and drainage holes at both ends of the plug, and there are no water droplets or water vapor inside, which does not affect the lighting effect.

5. The motor drive adopts epoxy resin sealing and bonding, and does not enter the water.

6. All solder joints of the lamp body are potted with high-efficiency waterproof silicone rubber.